Application process

Firstly prepare surface 

Clean (wash with detergent) and dry  the surface. Mould needs to be treated with bleach and rinsed with fresh water then. All surface defects need to be filled with a suitable filler.

Application steps

• Mix paint for 5 minutes before use
• Floor and furnishing must be covered
• Put on one coat of Tradex UltraPrep if needed.
• Then apply two coats of Tradex coat.  
• Use a 12 mm roller sleeve. 
• Put on extra coats if required by brush only.
• It is important to use good quality roller and brush.
• Use HVLP or Airless Spray ( up to 10% thinnes) if spray application is preferable. 
• 30 minutes (at 50% humidity and 25°C)  is a Drying time (touch dry). It may take longer dump or humid areas
• After 2 hours Recoat with water/oil based coat
• If temperatures below 10°C or above 35°C Do not paint
• Close the container lid if not using

Make sure the ventilation is adequate while using the paint

 During 48 hours keep away from condensation and steam. Surface can be washed only after 7 days!

• Covered area

Coverage depends on the surface roughness and porousness. Up to 16 m2 per litre.